Cannulated Drill 3.2/1.5 mm for Fracture Treatment - Article 550.060

Tool for the treatment of fractures. Used for insertion of cannulated screws. It is made of corrosion-resistant stainless steel.

Total length - 150 mm. Length of the cutting part - 37 mm. Diameter of the working part - 3.2 mm.

The working end is tapered obtuse-angled with two cutting edges. Two spiral-shaped troughs for the discharge of drilled material in the side walls along the entire working length of the tool. Cannulated design.

Internal through-hole diameter 1.6 mm. Shank type AO quick connect. Laser marking of the diameter on the drill bit.

Reusable.