Manual Wire Clamp for Spinal Surgery - Precision Tool for Transpedicular System Installation

Instrument for surgical treatment of the spine. It is used for installation of transpedicular system. It is made of corrosion resistant stainless steel.

The total length is 225 mm. The outer diameter is stepped: 20 mm at the edges and 18 mm in length, 15.5 mm in the middle. Inner through diameter 12.5 mm.

Handle - at an angle of 80 with a total length of 128 mm. The handle is textolite shaped with a diameter of 35 mm, length 113 mm. At the other end is an internal profile hole 10.2 mm wide, 14.2 mm long and 10.2 mm deep.

At the end, a groove 6.1 mm in diameter, 5.5 mm deep for gripping the longitudinal tie. Laser individual marking. Reusable.