Adjustable Single Student Desk with Tilted Surface for Enhanced Learning

The table top and front panel of the table are made of 16mm LDFP. The table top can be made of chipboard with plastic coating 26mm. Ends of the table top are closed with PVC edge thickness.

2mm. The ends of the front panel are covered with 0.5 mm PVC edgebanding. The metal frame is made of 25x25 mm and 20x20 mm square section profile with wall thickness not less than 1.2 mm and powder coated, resistant to chemical and mechanical influences.

At the free ends of the pipes there are plugs made of impact-resistant polymers. The frame of the table has polymer feet to prevent damage to the floor covering. All fixing fittings on m/frames are hidden inside the pipe to extend the service life of the product.

Front fixing on the table top is concealed (threaded bushings and M6 bolts). Rear fixing on the table top is through-through (furniture bolt with nut). The front panel is fixed to the frame with furniture bolts and nuts.

Height adjustment is carried out using screws with Erickson nut. Stepwise adjustment of the tilt angle from 0 to 75.